Grow guide · Iberian Mycology kits

An Iberian Mycology kit arrives fully colonised. Your job is small: give it light, humid air and a little patience. This is the manufacturer's method, rewritten by us with the details people ask about most.

What is in the box

  • 1200 ml kit, 100% colonised mycelium
  • Grow bag with zip
  • Bag of casing layer
  • Printed instructions

What you add

  • Tap water
  • A spray bottle with a fine mist
  • A clean spoon
  • A bright spot away from radiators and draughts

The bag method, in seven steps

This is the standard way. It takes two minutes a day.

  1. 1

    Open the kit

    Break the seal and lift off the lid. Keep the lid, you need it later. Do not add water: the kit holds all the moisture it needs for the first flush.

  2. 2

    Spread the casing layer

    Open the small bag of casing and spread it over the surface with a clean spoon, in a thin, even layer. It is optional, but it holds moisture where the pins form and gives you a better first flush.

    For Panaeolus cyanescens the casing layer is not optional. Always use it.

  3. 3

    Bag it

    Stand the kit in the grow bag. Mist the inside walls of the bag with tap water, never the kit itself, and close the zip halfway so air can pass.

    A finger of tap water in the bottom of the bag helps hold the humidity.

  4. 4

    Wait and watch

    Leave the kit alone. Mist the bag walls once or twice a day if they look dry. If the surface dries, close the zip a little more. If it looks wet, open it more.

  5. 5

    When the first pins show

    Tiny white dots with dark heads: these are the pins. Open the zip to two thirds. Twice a day, open the bag fully for ten minutes, then mist the walls again.

    Think of the zip in three parts and keep one part closed.

  6. 6

    Harvest

    Pick 5 to 6 hours after the veil under the cap tears. Hold the mushroom at its base, twist gently and pull. Do not dig into the surface: damage there delays the next flush.

  7. 7

    Soak and go again

    Take the kit out of the bag and fill it to the brim with tap water. Put the lid on and leave it 20 minutes at room temperature, never in the fridge. Drain it completely, put it back in the bag and start again at step 4.

Where the zip should be

Before pins

Half closed

Pins growing

Two thirds open

Airing, twice a day

Fully open for 10 minutes

The phone-light test

Most failed kits were sprayed too much, not too little. Before you mist the surface, check it.

  1. Shine your phone light across the surface.
  2. Tiny droplets glinting back? It is wet enough. Do nothing.
  3. No droplets? Take the kit out of the bag. Spray from at least one metre away, into the air above it, never at it. Let the mist fall for about 6 seconds, like fog on an autumn morning.
  4. Check again with the light. Mist the surface once a day at most.

Too wet is worse than too dry. Mycelium needs oxygen as much as it needs humidity: if water pools, open the zip further.

The box method, for less daily work

A transparent plastic box, a little larger than the kit, keeps humidity steady on its own. Good if you are away during the day.

  1. Pour 2 cm of tap water into the box.
  2. Take the lid off the kit, spread the casing layer and stand the kit in the water.
  3. Rest the box lid on top without clipping it shut. If the surface gets too wet, turn the lid over and leave a 1–2 cm gap.
  4. When the pins show, turn the lid upside down and slide it to leave at least a finger of gap. Widen it if moisture builds up.
  5. Do not mist the walls. Mist the surface only if the phone-light test says so, which is rare.
  6. Harvest and soak exactly as in the bag method, then put the kit back in the box.

Bag or box?

Grow bagPlastic box
IncludedYesNo, any clear box works
Daily workMist walls, air twice a dayAlmost none
HumidityYou manage it with the zipStable by itself
Best forWatching closely, first growBusy weeks, dry homes

What to expect, and when

Typical timings at 22–24 °C. Cooler rooms are slower, and every strain has its own pace.

  1. Day 0

    Kit opened, cased and bagged.

  2. Day 7–14

    First pins appear.

  3. 5–8 days later

    Veils tear: harvest.

  4. Same day

    Soak 20 minutes, back in the bag.

  5. 1–2 weeks later

    Next flush. Each one is a little smaller.

When something looks wrong

What you seeWhat it meansWhat to do
No pins after two weeksToo cold, too dark or too little fresh airMove it to a brighter spot at 22–24 °C and air it twice a day.
Surface dry or crackedHumidity too lowMist using the phone-light test and close the zip a little.
Water pooling on the surfaceToo much mistingStop misting, open the zip further.
White fuzz on the base of the stemsNot mould: the mushrooms want more fresh airAir longer and open the zip more.
Small pins turn dark and stopAborts, usually after a swing in humidityPick them with the harvest. Keep conditions steadier.
Blue stains on mycelium or stemsBruising from touch or waterHarmless. Carry on.
Green, black or pink patches, sour smellContaminationClose the bag, do not open it indoors, and throw the kit away.

Growing Panaeolus cyanescens (Copelandia TTBVI)

Same kit, same bag, three differences. It wants more warmth: 24–28 °C. It needs the casing layer to form pins, so always spread it. And it wants more fresh air than cubensis, so air it a little longer. The mushrooms are smaller and finer: harvest them when the caps have opened and turned pale.

After the harvest

Fresh mushrooms keep a few days in the fridge in a paper bag. To keep them longer, dry them on a rack with moving air, or in a dehydrator at low heat, until the stems snap. Store them airtight and in the dark.

Back to the grow kits

🍄 We use cookies to improve your experience and ensure secure shopping. By continuing, you accept our cookie policy.